GoodWe inverter error code 9
GoodWe uses code 9 in more than one product range, and it doesn't always mean the same thing. Check which range your inverter belongs to below.
WattMate is not affiliated with GoodWe. This page summarises GoodWe's own published documentation; your installer and GoodWe are the authority on your system. WattMate doesn't repair systems or make site visits.
As documented for Sbp G2
- Meaning
- Anti-islanding
- Likely cause
- The utility grid is disconnected according to the safety regulations, but the grid voltage is maintained due to loads.
- What the manual says to do
- Check whether the utility grid is disconnected. If the problem persists, contact the dealer or after-sales service.
- Manufacturer's severity
- Warning
Extracted from GoodWe's published manual. Check it against the manual for your model. Open the source document
As documented for Sdt G2
- Meaning
- Over Temperature
- Likely cause
- 1. The inverter is installed in a place with poor ventilation. 2. The ambient temperature is too high.
- What the manual says to do
- Check the installation environment and space of the inverter. Make sure that the ventilation meets heat dissipation requirements.
- Manufacturer's severity
- Warning
GoodWe's documentation says this one needs your installer.
Extracted from GoodWe's published manual. Check it against the manual for your model. Open the source document
When to call your installer or the warranty line
Your installer is your first warranty contact. If they've gone, the manufacturer's warranty line still covers the hardware. Don't open the inverter or battery case yourself: work inside it is for a licensed electrician.
If you see smoke, scorch marks or smell burning, switch the system off at the AC and PV isolators and call your installer. If anyone is in danger, call 000.
- GoodWe warranty phone
- 0399183905
- GoodWe warranty email
- service.au@goodwe.com
- GoodWe service network
- Open the manufacturer's service page